Site Logo
Site Logo
 
It is currently Mon Mar 27, 2017 11:11 am

All times are UTC




Forum locked This topic is locked, you cannot edit posts or make further replies.  [ 2 posts ] 
Author Message
 Post subject: Z Level strategy not finishing vertical walls
PostPosted: Tue May 17, 2016 3:59 pm 
Offline

Joined: Sun Sep 20, 2009 8:36 am
Posts: 40
Does anyone know why a Z level finish wont finish the vertical side walls of a part in one operation. The Z level rough cuts perfectly but the finish wont touch it.
Any ideas????


Attachments:
8.jpg
8.jpg [ 49.74 KiB | Viewed 1031 times ]
7.jpg
7.jpg [ 42.83 KiB | Viewed 1038 times ]
Top
 Profile  
 
 Post subject: Re: Z Level strategy not finishing vertical walls
PostPosted: Wed May 18, 2016 12:13 pm 
Offline

Joined: Fri Aug 22, 2008 2:54 am
Posts: 55
Location: Harrisburg, PA
Sometimes it has to do with check surfaces.
Uncheck as many surfaces as possible.
also open up your spline tolerance.
I also have selected the bottom or floor of the shape if possible and gave it a z level finish.


Top
 Profile  
 
Display posts from previous:  Sort by  
Forum locked This topic is locked, you cannot edit posts or make further replies.  [ 2 posts ] 

All times are UTC


Who is online

Users browsing this forum: No registered users and 6 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB