Site Logo
Site Logo
 
It is currently Mon Mar 27, 2017 11:08 am

All times are UTC




Forum locked This topic is locked, you cannot edit posts or make further replies.  [ 1 post ] 
Author Message
 Post subject: Z relative plunge
PostPosted: Mon Feb 01, 2016 9:03 pm 
Offline

Joined: Fri Aug 21, 2015 11:36 pm
Posts: 9
I thought I saw where the new version of FC had made it where we could do relative plunge on 2 1/2 features. I have looked everywhere, and if it is there, I can't find it. I use it when surface milling all of the time, and was excited to see that they had finally corrected that, but after installing the newest version, there is no where to enable it.


Top
 Profile  
 
Display posts from previous:  Sort by  
Forum locked This topic is locked, you cannot edit posts or make further replies.  [ 1 post ] 

All times are UTC


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB